Datsun Questions Maintenance & Repair
I Cannot Find A Tool To Diagnose The Computer On My 1983 Datson 280zx Turbo...
computer reader????? cannot find one
Should I Switch The Engine And Transmission Out Or Just The Transmission?
Just picked up a 1972 240Z with an automatic transmission (stuck in first gear). I'm not sure if I should fix the auto transmission, or just put a new engine and transmission in it. Any clue on what...
I Have A 1977 Datsun 280z My Lights And Horn Won't Work.
I have no power to my fuse box my head lights and horn won't work. All my other lights and my radio works. What should I look for
I Have A 1977 Datsun 280z With An A Starting Problem
I recently purchased a 1977, 280Z. Sometimes it starts with the key and sometimes, mostly, it doesn't. I know for sure it is not the battery and I have tested the starter and when I short wire it,...
Starting Problem After Run To Full Temp
I have a 1977 208z with fuel injection and after it has been driven and is up to full temp then turned off and I try to re-start it in say 15 minutes, it acts like a vapor lock. CHUG A LUG CHUG A LU...
1977 280z Heater Box Maintenance
won't switch between heat and defrost
ON A 1977 WHERE DOES THE BLACK FUSIBLE LINK GO?
IN THE 1977 Datsun 280z THERE IS TWO BOES ON THE PASSENGER SIDE FOR FUSIBLE LINKS. each BOX CONTAIN TWO FUSIBLE LINKS. the FUSIBLE LINKS FROM NISSAN CONTAIN THREE THAT ARE TAN AND ONE WHICH IS BLACK. ...
1979 280zx 5 Speed. Car Starts . Barely Idles. When I Push Accelerator, E...
Changed plugs, wires, fuel filter, and throttle valve switch.
?why Won.t My 1978 280 Z Car Start After A Little Water Overspray?
I started my 78 280Z and washed it while it was running it with the hood open slightly. After I shut it off again, it would not restart. All I get is a faint clicking noise under the hood when I tr...
Its A 1978 Datsun 280z, Randomly, The Car Will Start Running To Rich To Run...
Randomly, the car will start running to rich to run properly, i can adjust the Air flow meter to copensate, however, once done so, and it stops dumping the fuel, it runs too lean and needs to be adj...
Misfire ?
problems with acceleration i changed distributer cap rotor gaz pump filters plugs it drives and then it takes off then it hesitates two sparkplugs fire well two injecters fire well the other four ar...
Have A 77 280z And I Have Changed Ignition Coil The Pickup Coil And It Sti...
I have a 1977 datsun 280z changed ignition coil and pickup coil and it still won't fire help please
Have A 1975 A14 Datsun Engine Used As A Power Plant. When You Attempt To S...
Details are in my question.
Why Are My Gauges Erratic On My 77?
The gauges go to appropriate levels at starting, then - in unison - the temp, oil pressure and fuel level all slowly go to zero, then head back up some then head back down some, etc. If it weren't al...
Having Trouble With Power Drain With Ignition Off
I have a 1983 Datsun 280ZX. After sitting for a couple days it will not start. I have replaced the battery, had my car checked out by a mechanic who found nothing wrong such as a bad alternator, e...
74 Datsun Pu How Do You Determine The Size Of The Center Support Bearing 16...
there are two sizes of center support bearings 16mm and 22mm how do you know what size to get. where do get this dimension from
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.