Chevrolet C/K 20 Questions Maintenance & Repair

1978 Chevy 350 Won't Run

My truck will crank and start when gas dumped down the carburetor. After that it stalls. It will idle as long as I keep dumping gas in the carb. Anyone have any ideas on what could be wrong with it...

79' Chevy K20 Custom Deluxe Will Not Turn Over.

I recently bought a 1979 Chevy K20 Custom Deluxe and it will not turn over. The first day I got the pickup, it ran perfectly fine. I drove it about a few miles or so and then it just stopped. No hiccu...

78 C20 2main Bolts And 4 Main Bolts Engine Bolt Pattern Disfferences For A ...

ok,well i dont know if its a 2main or 4 main. But do those 2 types of engines have identical bolt patterns like the intake manifold exaust manifold coolant pump fuel pump and acceries(alt power st...

No Power To Hazard Flasher On Fuse Panel Underdash, Key On, Hazard Switch O...

I had an emergency and when I activated my hazard switch, by pulling it out, nothing happend. I checked the fuse panel prongs (two) where the hazard flasher plugged in, and no power. I turned on the...

Battery Gauge Don't Move

I have a 95 chevy c20 pickup with battery gauage that don't move lights bright starts fast no drag got dash lights turn signal been driving this way for 5 days could truck be charging battery

1976 K20

My passenger side rear turn signal and break light don't work, I have a tail light but no turn signal or break, the front passenger side Turn signal and flasher works, along with everything on the ...

My 84 Chevy K20 As I Was Driving About 82 Miles From My Home, As I Reached ...

is my problem the oil filter because that could of been what I lost when it started acting up. I'm getting a ride to were its at but I was hoping somebody couldlet me know if I buy the oil filter and ...

82 350 Spiiting

Recently bought an 82 k20 350 with "carberator" problems. Rebuilt the carb, replaced the plugs, set the timing. Cranks right over and idles like a champ but runs like absolute junk. At a lose at th...

1983 Chevy Truck Diesel

I have a 1983 Chevy truck diesel it cranks over but wont turn on

Should My Truck Be Running While Bleeding The Brakes?

1978 Chevy C20

I replaced my electronic ignition switch and neutral safety switch in my 1978 chevy c20 and when I turn my key I gotta turn it almost to start position to bring power to the cab of the truck and e...

What Is This -pretty Please Tell Me

i dont knnow what this part is and I really am going crazy trying to figure it out, I know it says Chevrolet but I have no idea, it measures 48"x19" I have spent days trying to figure it out, s...

I Have A 1986 Chevy Silverado S20 Pickup That Turns Over And Will Start For...

Have a 1986 Chevy Silverado with 59000 original miles. Has bad bearings and so I only use it once a month to haul trash to the landfill. I rarely use it and when I tried to start it a week ago the b...

Fuel Not Getting Fuel To The Fuel Filter

I got an 81 Chevy Scottsdale K20 four- wheel drive long bed to fuel filter I replace the fuel pump and filled it with gas still no fuel what could it be?

82 Chevy C20 Starts Won't Stay On

I'm working on a 82 chevy c20, recently have done all spark plugs, spark plug wires, distributor cap, starter, alternator, alternator plug, battery, and the truck starts runs for awhile then dies....

Spark Knock During Acceleration On Incline's

Spark knock during acceleration on inclines

Carburetor Swap

Can I take a carburetor from my 1993 Chevy Silverado and install it in my 1978 Chevy Scottsdale the 78 has a Rochester model a quadrajet carburetor or that's what i think The carb needs to be reb...

1979 K20

I'm actually at a loss, my truck wont turn over or even click at the starter, I have replaced the starter, ignition switch, safety neutral switch, starter relay, fuses, and followed the wiring and ...

Oil Pressure

86 SQUARE BODY 4X4 Just changed oil pump the gauge was reading before change but now its saying i have 0 oil pressure just wondering if anybody has ever had this problem.

Can I Reattach The Clucth Fan Mount On My Waterpump?

After i replaced my waterpump the seal on one side didnt hold, and when it blew it popped the mounting pully off that i attache my clutch fan to. Can i fix this or do i need a new pump?