Asked by GuruTL3VH Jun 29, 2018 at 02:39 PM about the 2010 Ford Edge Limited
Question type: Maintenance & Repair
My CE light came on after car ran hot. Temp gauge went up to H, needed lots
of coolant. After adding gallon of coolant, temp gauge went to normal but CE
light stayed on. Getting ready to check OBD for code. Runs better and AC
works fine. What next?
Did you have a look at your engine oil? Hopefully there is not coolant in there. A broken water pump on those engines will throw the timing off, and most likely post several codes.
Have not yet but I will. Thanks for suggestion. Will post resolution when found.
My CE light came on after car ran hot. Temp gauge went up to H, needed lots of coolant. After adding gallon of coolant, temp gauge went to normal but CE light stayed on. Getting ready to check OBD ...
2010 Ford Edge Limited
-
Maintenance & Repair
2012 Edge, CE light came on yesterday. I was very low on fuel. Car filled today. Light on. Dis connected battery for 20 min plus. after reconnect, light on immediately. Shouldn't the light be out u...
2012 Ford Edge
-
Maintenance & Repair
I have a check engine light on and the code is P2196 , anyone have suggestions. The other codes that came up were : P0456, P2198, P0456
2014 Ford Edge Limited AWD
-
Maintenance & Repair
Over the last few days check engine light cane on then off on then off. Codes read P1289, P26AC, P128A, P061A. Happened after inspection and oil change . Thoughts?
2013 Ford Edge Sport
-
Maintenance & Repair
Engine light on
2012 Ford Edge Limited
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.