stalling problems 99 blazer

Asked by Chris Dec 01, 2014 at 06:27 PM about the Chevrolet S-10 Blazer

Question type: Maintenance & Repair

sometime my s10 blazer stalls out I have replaced the tpi I have also replaced the plugs rotor and distributor the fuel pump was replaced 2.5 years ago it is not all the time fuel pressure is 55lbs. when it runs when it stalls sometimes it will start right up and sometimes it takes a few mins to restart . also when I am driving I am pushing on the gas but it does not seam to want to excelerate

4 Answers
45

suzykate answered 9 years ago

I'm having a similar problem, except mine is fine on the highway and struggles to stay running in town. Also has starting problems every day, it turns over but have to try several times to get it to start.

Best Answer Mark helpful
480

jd3938 answered 9 years ago

check for all vacuum leaks. mine had two hoses disconnected

1 people found this helpful.
Mark helpful
45

suzykate answered 9 years ago

Thanks, turns out the egr valve kept getting stuck with carbon chunks in it. A friend and u cleaned it and put a screened gasket and it helped. Next my muffler got a hole in it. Couldn't fix it right away. It started a fire under it while I was driving it. long story short, it is parked until further notice. :(

Mark helpful

Your Answer:

Related Questions

  • stalling problems 99 blazer 4 Answers

    sometime my s10 blazer stalls out I have replaced the tpi I have also replaced the plugs rotor and distributor the fuel pump was replaced 2.5 years ago it is not all the time fuel pressure is 55lbs. w...

    Chevrolet S-10 Blazer

    -

    Maintenance & Repair

  • I have a 1993 s-10 Blazer fuel pump fuse size 5 Answers

    I have a 1993 s-10 Blazer with the 4.3 liter Vortex under the hood. It is 4 wheel drive adn i keep blowing the fuse for my fuel pup. it has a 10 amp fuse put in the slot. Is that the correct size? I h...

    1993 Chevrolet S-10 Blazer

    -

    Maintenance & Repair

  • can you put an erg valve upside down on 1988 s-10 blazer with 4.3 l engine 4 Answers

    I replaced the ERG valve on a 1988 S-10 Blazer with the 4.3 liter engine. it would barely run after I did this. I took it to a repair shop and they told me I put it on upside down. is this possible ?

    1988 Chevrolet S-10 Blazer Tahoe

    -

    Maintenance & Repair

  • My blazer 1 Answer

    So my 86 s10 blazer was running after i replaced the coil pack spark plug and wires started no problem had it running and the coil pack fryed ive replaced the coil pack again and same thing idk wha...

    1986 Chevrolet S-10 Blazer

    -

    Maintenance & Repair

  • 2002 blazer 4wd not engaging 3 Answers

    I have a 2002 blazer that shows its engaging on switch btu it is still in 2wd. I have pulled the cable off the actuator and ran it - replaced actuator and its working properly.The cable is free to mov...

    Chevrolet S-10 Blazer

    -

    Maintenance & Repair

S-10 Blazer

Looking for a Used S-10 Blazer in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

Shortcuts

Search Chevrolet S-10 Blazer Questions

CarGurus Experts

  • #1
    Cody Doud
    Reputation
    1,220
  • #2
    Jeremy Roadman
    Reputation
    920
  • #3
    Markfisler
    Reputation
    710
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Chevrolet S-10
2 listings
Used Chevrolet Blazer
18 Great Deals out of 1,138 listings starting at $3,000
Used Chevrolet Silverado 1500
200 Great Deals out of 8,052 listings starting at $1,500

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.