Ford Bantum 1.3 have sparks and petrol but not starting

Asked by GuruSBDKW May 24, 2019 at 02:45 PM about the Ford Bantam

Question type: Maintenance & Repair

Too much petrol but not starting

1 Answer

16,315

Check the Power hold relay, The fuel pump relays and check the Impact switch button on the left side A pillar under the dash is pressed in. If this impact switch is tripped, it switches off the fuel pump. Check the condition of the battery and starter. If the starter motor does not crank the engine over fast enough, the engine wont start. Check also the amperage draw on the mane starter cable as this could be drawing too much current. Check also that the starter selonoid cable harness is well away from the crank angle sensor wiring.

Your Answer:

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,010
  • #2
    Janus Welgemoed
    Reputation
    1,140
  • #3
    MrRocket12
    Reputation
    1,110
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.