Check engine light still on after numerous repairs
New master cylinder, purge valve, and
fuel pump installed but cel remains on.
Asked by Countrygyrl Jul 24, 2018 at 11:01 PM about the 2007 Mazda MAZDA3
Question type: Maintenance & Repair
New master cylinder, purge valve, and
fuel pump installed but cel remains on.
New master cylinder, purge valve, and fuel pump installed but cel remains on.
2007 Mazda MAZDA3
-
Maintenance & Repair
Every time I try to erase the check engine light my car kinda stalls in a way and erases the code and then check engine light comes right back on also the battery light is on also with the check en...
2004 Mazda MAZDA3 s
-
Maintenance & Repair
So I had a mobile mechanic stop by for a weekend and replace the transmission in my vehicle. He said he was able to get the job done very easily and didn't run into any issues. After everything wa...
2016 Mazda MAZDA3 i Grand Touring Hatchback
-
Maintenance & Repair
Hi. I've got a Mazda 3 2007 1,6 diesel. The car is making a weird clicking noise. The noise get's progressively worse but it isn't consistent at any RPM. I've changed the particle filter and a vent ...
2007 Mazda MAZDA3 s Touring Hatchback
-
Maintenance & Repair
I have a 2007 mazda3 2.0 with 96,000m and recently when I've gone to put gas the engine stalls a few times before finally turning over and staying on. This only happens when I put gas, otherwise my ca...
2007 Mazda MAZDA3 i Sport
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.