1979 Ford bronco 400 engine

Asked by Guru1CRBL Sep 05, 2019 at 07:36 PM about the 1979 Ford Bronco

Question type: Maintenance & Repair

Hi I was just wondering if a 1979 Ford bronco had a check engine light so you
can get codes out of it. Thanks

1 Answer


Your truck would have had the EEC II system, EEC I and II were essentially the same, by 1980 there were replaced by EECIII. You can google a "how to" on reading an EEC II code. EEC II is a rudimentary system, not sure any codes it could offer would be much use, it mostly deals with the smog motor/EGR and VV carb. It's possible to read EECIII and EECIV codes in diagnostic mode by counting the flashes on the CEL, not sure if that can be done with the older EECII. There is no code reader, per se, for reading that system.

Your Answer:

Ford Bronco Experts

  • #1
    G A Arne
  • #2
    Clayton Cameron
  • #3
View All

Find great deals from top-rated dealers


Related Models For Sale

Used Ford F-150
82 Great Deals out of 5,942 listings starting at $2,450
Used Ford Mustang
38 Great Deals out of 904 listings starting at $2,495
Used Chevrolet Blazer
694 listings starting at $31,888
Used Ford F-250
1 listing

Used Cars for Sale

2021 Ford Bronco For Sale
5 listings starting at $40,199

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.