I'm replacing pinion bearing in front diff of a Dana 30. What is the proper way to shim pinion gear?

I'm replacing pinion bearing in front diff of a Dana 30. What is the proper way to shim pinion gear? 1 Answer

I am replacing front differential ring pinion bearing and seal 373 ratio how hard is it to get the proper torque 1 Answer

I have all the parts Im worried about it being torqued properly after installation

pinion seal/bearing replacement cost 2 Answers

i have a 2000 grand cherokee larado with the 4.0 select-a-trac i need to have my front pinion bearing and seal replaced how much could that run at 75$ per hour

Does a leaking drive shaft pinion outer seal on a 1998 Jeep Grand Cherokee cause the internal rear differential pinion setup to lose its preload and need to be replaced. 1 Answer

Is the following Jeep dealer guidance correct? The seal where the drive shaft pinion enters the rear differential leaks. It may have leaked for some time as it has sprayed the underneath of the body ...

Front end differential gear ratio and diff assembly 1 Answer

I have a 99 grand cherokee and am rebuilding the front end, all of the bearings were shot. I do not know what the gear ratio should be any way of finding out?