Codep2127

30

Asked by GuruDJ3Y Mar 23, 2017 at 02:01 PM about the 2004 Hyundai Santa Fe

Question type: Maintenance & Repair

2004 hyundai santa fe
Lost power driving along ,check engine came on p2127 any heip would be great
,i think it has something to do with my throttle controler ,this all happened after
picking up my car at shop getting my exhaust fix ,i dont think it has anything to
do with what they did who nose any help on thus would be great thanks

2 Answers

220,515

P2127 HYUNDAI - Accelerator Position Circuit - Low Input...Possible causes; Faulty Accelerator Pedal Position (APP) Sensor, Accelerator Pedal Position (APP) Sensor harness is open or shorted, Accelerator Pedal Position (APP) Sensor circuit poor electrical connection, Faulty Powertrain Control Module (PCM)...Description, the Accelerator Pedal Position (APP) sensor is an input to the Powertrain Control Module (PCM) and used to determine the amount of torque requested by the operator. There are 2 pedal position signals in the sensor. Both signals, APP and APP2, have a positive slope (increasing angle, increasing voltage), but are offset and increase at different rates. The 2 pedal position signals make sure the PCM receives a correct input even if 1 signal has a concern. The PCM determines if a signal is incorrect by calculating where it should be, inferred from the other signals. If a concern is present with one of the circuits the other input is used. There are 2 reference voltage circuits, 2 signal return circuits, and 2 signal circuits (a total of 6 circuits and pins) between the PCM and the APP sensor assembly. The pedal position signal is converted to pedal travel degrees (rotary angle) by the PCM. The software converts these degrees to counts, which is the input to the torque based strategy. The accelerator pedal position (APP) sensor 2 is out of self-test range low.

Best Answer Mark helpful
30

Thank you for the info much appreciated, the veh seems to be running ok at the moment ,ill check connection under the dash at the switch on gas pedal, and at the throttle plates ,iam going to try to borrow a snap on scan tool to check the % of throttle angle percentage (volts ) ,cant make it do the problem running good so far ,do you no if they had any issues with the switch at the pedle?thanks again for your help very much appreciated!

Your Answer:

CarGurus Experts

  • #1
    me29
    Reputation
    6,540
  • #2
    JP1956
    Reputation
    2,810
  • #3
    SubaruTech5862
    Reputation
    2,010
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Hyundai Tucson
105 Great Deals out of 2,551 listings starting at $2,295
Used Kia Sorento
69 Great Deals out of 1,714 listings starting at $1,500
Used Honda CR-V
156 Great Deals out of 4,959 listings starting at $440
Used Toyota RAV4
124 Great Deals out of 2,931 listings starting at $6,950
Used Toyota Highlander
44 Great Deals out of 818 listings starting at $8,495
Used Honda Pilot
29 Great Deals out of 790 listings starting at $2,495
Used Hyundai Sonata
54 Great Deals out of 831 listings starting at $3,995
Used Ford Explorer
57 Great Deals out of 2,220 listings starting at $7,990
Used Kia Sportage
59 Great Deals out of 1,940 listings starting at $3,999

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.